Microchip’s dsPIC33E family of digital signal controllers (DSCs) features a 70 MIPS dsPIC® DSC core with integrated DSP and enhanced on-chip peripherals. These DSCs enable the design of high-performance, precision motor control systems that are more energy efficient, quieter in operation, have a great range and extended life. They can be used to control brushless DC, permanent magnet synchronous, AC induction and stepper motors. These devices are also ideal for high-performance general purpose applications

Operating Conditions

  3.0V to 3.6V, -40ºC to +85ºC, DC to 70 MIPS

  3.0V to 3.6V, -40ºC to +125ºC, DC to 60 MIPS

dsPIC33E DSC Core

  Modified Harvard Architecture

  C Compiler Optimized Instruction Set

  16-bit Wide Data Path

  24-bit Wide Instructions

  16x16 Integer Multiply Operations

  32/16 and 16/16 Integer Divide Operations

  Two 40-bit Accumulators with Rounding and Saturation Options

  Single-Cycle Multiply and Accumulate

  Single-Cycle shifts for up to 40-bit Data

  16x16 Fractional Multiply/Divide Operations

High-Speed PWM

  Up to three PWM pairs with independent timing

  Dead time for rising and falling edges

  7.14 ns PWM resolution

  PWM support for:

  Inverters, PFC, Lighting

  BLDC, PMSM, ACIM, SRM

  Programmable Fault inputs

  Flexible trigger configurations for ADC conversions

Advanced Analog Features

  ADC module:

  Configurable as 10-bit, 1.1 Msps with four S&H or 12-bit, 500 ksps with one S&H

  Up to three Op amp/Comparators:

  Op Amp direct connection to the ADC module

  Additional dedicated comparator

  Programmable references with 32 voltage points for comparators

  Charge Time Measurement Unit (CTMU):

  Supports mTouch™ capacitive touch sensing

Timers/Output Compare/Input Capture

  12 general purpose timers:

  Five 16-bit and up to two 32-bit timers/counters

  Four OC modules configurable as timers/counters

  PTG module with two configurable timers/counters

  32-bit Quadrature Encoder Interface (QEI) module configurable as a timer/counter

  Four IC modules

  Peripheral Trigger Generator (PTG) for scheduling complex sequences

Communication Interfaces

  Two UART modules (15 Mbps)

  Two 4-wire SPI modules (15 Mbps)

  ECAN™ module (1 Mbaud) CAN 2.0B support

  Two I2C™ modules (up to 1 Mbaud) with SMBus support

  PPS to allow function remap

  Programmable Cyclic Redundancy Check (CRC)

Direct Memory Access (DMA)

  4-channel DMA with user-selectable priority arbitration

  UART, SPI, ADC, ECAN, IC, OC, and Timers