LMK04806
具有双级联 PLL 和集成 2.5 GHz VCO 的低噪声时钟抖动消除器
制造商:TI
产品信息
描述 The LMK0480x family is the industrys highest performance clock conditioner with superior clock jitter cleaning, generation, and distribution with advanced features to meet next generation system requirements. The dual loop PLLatinum architecture is capable of 111 fs rms jitter (12 kHz to 20 MHz) using a low noise VCXO module or sub-200 fs rms jitter (12 kHz to 20 MHz) using a low cost external crystal and varactor diode.The dual loop architecture consists of two high-performance phase-locked loops (PLL), a low-noise crystal oscillator circuit, and a high-performance voltage controlled oscillator (VCO). The first PLL (PLL1) provides low-noise jitter cleaner functionality while the second PLL (PLL2) performs the clock generation. PLL1 can be configured to either work with an external VCXO module or the integrated crystal oscillator with an external tunable crystal and varactor diode. When paired with a very narrow loop bandwidth, PLL1 uses the superior close-in phase noise (offsets below 50 kHz) of the VCXO module or the tunable crystal to clean the input clock. The output of PLL1 is used as the clean input reference to PLL2 where it locks the integrated VCO. The loop bandwidth of PLL2 can be optimized to clean the far-out phase noise (offsets above 50 kHz) where the integrated VCO outperforms the VCXO module or tunable crystal used in PLL1.特性Ultra-Low RMS Jitter Performance 111 fs RMS Jitter (12 kHz to 20 MHz) 123 fs RMS Jitter (100 Hz to 20 MHz) Dual Loop PLLatinum™ PLL Architecture PLL1 Integrated Low-Noise Crystal Oscillator Circuit Holdover Mode when Input Clocks are Lost Automatic or Manual Triggering/Recovery PLL2 Normalized PLL Noise Floor of –227 dBc/Hz Phase Detector Rate up to 155 MHz OSCin Frequency-Doubler Integrated Low-Noise VCO 2 Redundant Input Clocks with LOS Automatic and Manual Switch-Over Modes 50 % Duty Cycle Output Divides, 1 to 1045 (Even and Odd) 12 LVPECL, LVDS, or LVCMOS Programmable Outputs Digital Delay: Fixed or Dynamically Adjustable 25 ps Step Analog Delay Control. 14 Differential Outputs. Up to 26 Single Ended. Up to 6 VCXO/Crystal Buffered Outputs Clock Rates of up to 1536 MHz 0-Delay Mode Three Default Clock Outputs at Power Up Multi-Mode: Dual PLL, Single PLL, and Clock Distribution Industrial Temperature Range: –40 to 85°C 3.15-V to 3.45-V Operation 2 Dedicated Buffered/Divided OSCin Clocks Package: 64-Pin WQFN (9.0 × 9.0 × 0.8 mm)
电路图、引脚图和封装图
在线购买
技术资料
204B实战应用-LMK04821代码详解(二)...天给各位大侠带来一篇项目开发经验分享“基于JESD204B的LMK04821芯片项目开发”第二篇,这是本人实打实的项目开发经验,希望可以给有需要的大侠提供一些参考学习作用。 以后机会多多,慢慢分享一些项目开发以及学习方面的...
2021-10-08
基于JESD204B的LMK04821芯片项目详解...天给各位大侠带来一篇项目开发经验分享“基于JESD204B的LMK04821芯片项目开发”第二篇,这是本人实打实的项目开发经验,希望可以给有需要的大侠提供一些参考学习作用。 以后机会多多,慢慢分享一些项目开发以及学习方面的...
2021-04-05
FPGA项目开发精选:204B实战应用-LMK04821代码详解我们在配置LMK04821寄存器时,要验证配置寄存器操作是否正确,就要有写有读,在对应的寄存器内写入对应的数值,然后进行读操作,观察正确性。本次设计是在vivado环境下进行设计,通过添加VIO的IP核,来控制读写操作。同时,添加ILA配合VIO来进行读写数据操作的观测。别的开发环境下思路一样。
2023-01-05
基于JESD204B的LMK04821芯片项目开发 LMK0482X系列是德州仪器推出的高性能时钟调节芯片系列,该芯片目前有三种,分别为LMK04821、LMK04826以及LMK04828,该系列芯片都支持最新的JESD204B协议。本次调试主要以LMK04821为例,对调试过程中出现的一些问题进行总结说明。
2023-01-05
2020-04-21
浅析设计宽带宽 多通道系统的逐步注意事项Other Parts Discussed in Post: ADC12DJ3200, ADC12DJ5200RF, LMK04828, LMX2594, LMK61E2下一代航天和国防以及测试和
2022-01-20
采用系统参考模式设计JESD 204B时钟中,笔者将谈论抖动合成器与清除器的不同系统参考信号(SYSREF)模式,以及如何用它们来最大限度地提高JESD204B时钟方案的性能。
LMK04821系列器件为该话题提供了很好的范例研究素材,因为
2021-11-24
LMK04821芯片项目代码详解大侠好,阿Q来也,今天是第二次和各位见面,请各位大侠多多关照。今天给各位大侠带来一篇项目开发经验分享“基于JESD204B的LMK04821芯片项目开发”第二篇,这是本人实打实的项目开发经验,希望
2021-10-09