LM2904-N
制造商:TI
产品信息
描述 The LM158 series consists of two independent, high gain, internally frequency compensated operational amplifiers which were designed specifically to operate from a single power supply over a wide range of voltages. Operation from split power supplies is also possible and the low power supply current drain is independent of the magnitude of the power supply voltage.Application areas include transducer amplifiers, dc gain blocks and all the conventional op-amp circuits which now can be more easily implemented in single power supply systems. For example, the LM158 series can be directly operated off of the standard 3.3-V power supply voltage which is used in digital systems and will easily provide the required interface electronics without requiring the additional ±15V power supplies.The LM358 and LM2904 are available in a chip sized package (8-Bump DSBGA) using TIs DSBGA package technology.特性 Available in 8-Bump DSBGA Chip-Sized Package, (See AN-1112, SNVA009) Internally Frequency Compensated for Unity Gain Large DC Voltage Gain:100 dB Wide Bandwidth (Unity Gain):1 MHz (Temperature Compensated) Wide Power Supply Range: Single Supply:3V to 32V Or Dual Supplies:±1.5V to ±16V Very Low Supply Current Drain (500 µA)Essentially Independent of Supply Voltage Low Input Offset Voltage:2 mV Input Common-Mode Voltage Range Includes Ground Differential Input Voltage Range Equal to the Power Supply Voltage Large Output Voltage Swing Unique Characteristics: In the Linear Mode the Input Common-Mode Voltage Range Includes Ground and the Output Voltage Can Also Swing to Ground, even though Operated from Only a Single Power Supply Voltage. The Unity Gain Cross Frequency is Temperature Compensated. The Input Bias Current is also Temperature Compensated. Advantages: Two Internally Compensated Op Amps Eliminates Need for Dual Supplies Allows Direct Sensing Near GND and VOUT Also Goes to GND Compatible with All Forms of Logic Power Drain Suitable for Battery Operation
电路图、引脚图和封装图
在线购买
2017-08-29
2017-08-29
线性光电隔离电子电路的设计光电隔离是数据采集和控制系统抗干扰的一项重要措施,由于光电耦合器件的非线性,对模拟量的光电隔离会带来较大信号失真。为了提高光电隔离电路的线性度,采用负反馈方法把光耦器件的输出电流反馈输入端。进行光电隔...
2017-08-29
PTC热敏电阻汽车温度指示器该电路用于指示两个不同的水温触发点,当温度达到设定值是,LED发光。该电路围绕LM2904双运放大器,从12V汽车系统供电。热敏电阻与一个10k电阻串联,与9.1V电源正极并接地。
2017-08-29
使用LM317-N创建一个简单LED驱动器LM317-N 曾经是首个可调电压稳压器,推出时间要追溯到1975年。作为恒定电压电源,它仍在行业中得到广泛使用。不过,你知道吗,这种器件的功能可不仅仅是调节电压?它的多用途架构使你不但能够将其用为电压稳压器,还可以...
2017-08-29
2017-08-29
2017-08-29
2017-08-29